01 - Open the log and skim the face
From time to time you will need to check over your adjustments to ensure your mill is performing 100% efficiently. Please find a quick guide to help you along.
From time to time you will need to check over your adjustments to ensure your mill is performing 100% efficiently. Please find a quick guide to help you along.
Judge by the gap. Tooth to slab face at position A. Tooth to slab at position B. These two gaps must be within .25mm of each other (they need to be equal by eye).
Judge by the gap. Tooth to slab face at position C. Tooth to slab at position D. The tooth to slab position at D needs to be scraping the slab face. The tooth position at C should have a 2-4mm gap to the slab face.
Perform a deep cut to the far-left edge of the log (ensure you have water on the blade). You may need to skim this face again very slow if the adjustments are extremely out to start with. Once achieved position the vertical blade next to the face.
This is the final and easiest adjustment.
Please find a guide showing the assembly and operation of your Automated Turbosawmill.